Pilot or trial cell
Identify the metallization route and report the target deposit profile and trial fixture geometry.
Assess anodes for the copper electroplating step in PV cell metallization using the line layout, active plating area and deposit targets.

The anode review starts at the copper plating station. The wafer orientation, parts of the surface exposed to the bath and fixture arrangement define where the electrode must work.
Identify the metallization route and report the target deposit profile and trial fixture geometry.
Share the station drawing, wafer handling direction and which lines, faces or zones are plated.
Review candidate coated anodes using the station-specific bath, electrical load and deposition targets.
| What to compare | What to provide | What it helps confirm |
|---|---|---|
| Metallization and exposed area | Describe the plating step, exposed features and single- or double-sided arrangement. | Which side and part of the cell require an active anode face. |
| Fixture and movement | Supply the wafer envelope, fixture layout and available gap or travel. | Whether plate or mesh forms can fit the cell configuration. |
| Bath and electrical load | State the approved chemistry, waveform and normal load range. | Which coating candidates merit evaluation in the trial bath. |
| Deposit targets | Share the planned thickness or distribution criteria and acceptance method. | How the process owner can compare trial results. |
Consider MMO-coated plate or mesh where the process calls for an insoluble anode. Finalize the coated zones, contacts and acceptance checks on the specific plating station.
Review the general bath, mounting and electrical information needed.
Identify which inspection records to request for trial parts.